How to Download and Install Neostampa RIP Software Using Your Quick Start Guide

This video walks you through how to download and install Neostampa using the Quick Start Guide. This example uses the R2 Pro, but the process is similar for other supported models.

1. Make sure you have the Quick Start Guide PDF.
2. Double-click the Quick Start Guide PDF.
3. The PDF will open in your internet browser.

• If you do not have it, contact your dealer to request the PDF.

1. Scroll down in the Quick Start Guide.
2. Click on “Importing Resources.”
3. Locate the Neostampa folder.
4. For this example, scroll to the bottom and select the R2 Pro section.
5. Click the Neostampa RIP download link.

1. Click “Download.”
2. If prompted, click “Download Anyway.”
3. Note: The version number may change over time.
4. Allow the download to complete.

• In this example, version 25.20 is being downloaded.

• ICC profiles are located in the Neostampa folders.
• Downloading and installing ICC profiles will be covered in the next Neostampa setup video.

1. Double-click the downloaded Neostampa installer.
2. Select your preferred language.
3. Click “OK.”
4. Accept the license agreement.
5. Click “Next.”
6. Click “Next” again.
7. Click “Install.”

1. Installation time may vary depending on computer specifications.
2. Once installation is complete, click “Finish.”

• Typically takes less than 10 minutes.

Neostampa has now been successfully installed. Proceed to the next Neostampa setup video to learn how to launch and configure the software.